HOW TO TURN ON THE POWER
1 Plug in the power cord (see page 8).
2 | Locate the reset/off |
|
|
|
circuit breaker on the |
|
|
| |
|
|
|
| |
| treadmill near the power |
| Reset |
|
| cord. Make sure that |
| Position |
|
| the circuit breaker is in |
|
|
|
|
|
|
| |
| the reset position. |
|
|
|
|
|
|
|
Stand on the foot rails of the treadmill. Find the clip
3 attached to the key (see the drawing on page 9)
and slide the clip onto the waistband of your clothes. Next, route the cord attached to the clip under the handgrip pulse sensor, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1 Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is in- serted, the manual mode will be selected and the indicator on the
Manual button will light. If you have selected a
program, reselect the manual mode by pressing the Manual button.
3 Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the twelve Lightspeed buttons.
If the Start button or the Speed increase button is pressed, the walking belt will begin to move at 1 mph. As you exer-
cise, change the speed of the walking belt as de- sired by pressing the Speed increase and de- crease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in in- crements of 0.5 mph.
If one of the Lightspeed buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting. Indicators on the button that you press will flash while the speed of the walking belt is changing.
CAUTION: The Lightspeed bar is not intended to be used as a handlebar. If you hold the han- dlebar for support, you may unintentionally press one of the Lightspeed buttons, causing the speed of the walking belt to increase.
To stop the walking belt, press the Stop button. The time will begin to flash in the Time/Pace dis- play. To restart the walking belt, press the Start button, the Speed increase button, or one of the twelve Lightspeed buttons.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 24).
4 Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the Incline increase and de- crease buttons. Each time a button is pressed, the incline will change by 0.5%.
Follow your progress with the matrix and the
5 displays.
The matrix—When the
manual mode or the iFIT.com mode is se- lected, the matrix will display a
dicators around the track
will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.
10
