ProMaster 300C owner manual Package includes, Description

4.Synch Cord

Link the studio flash to your camera with a synch cord to trigger the light. You may also use the built-in slave sensor to trigger your flash.

5.Audio Signal

Setting the audio signal button (10) to the ON (I) position will activate an audio signal to remind you when the flash has been fully recharged. Set the button to the OFF (O) position will disable the audible signal.

6.Modeling Lamp

To turn the lamp off, set the switch (5) to “0”. When set to "=", the modeling lamp is on at full power. When set to the "-" position, the modeling lamp varies in brightness as you turn the output control button (13). Press the DIM switch (6) to the "I" position and the modeling lamp will turn itself off when the flash is fired and then will turn on automatically when the flash is fully charged.

7.Adjust Output Power for Flash

Use the flash power adjustment knob (13) for the desired exposure. The power level can be set continuously from 1/32 to full power.

8. Attaching the Reflector

The reflector has 3 pins around the perimeter of its base. Line these pins up with the corresponding notches in the flash head front collar. Rotate the reflector clockwise until it locks into position To remove the reflector, push the locking lever on the top of the flash head and rotate the reflector counter clockwise, then pull it way from the flash head.

9.Replacing flash tube

Wear gloves whenever removing the flash or modeling lamp. When replacing the flash tube, first remove the modeling lamp, then insert the flash tube. DO NOT TOUCH the anode OR cathode of the flash tube.

Package includes:

Description	QTY
PROMASTER SystemPRO 300C Flash	1
15' Power Cable	1
15' Synch Cord	1
7" Standard Reflector	1
150W Modeling Lamp	1
Protective Cover	1
Owner’s Manual	1