Step 6: Connecting the Power
23
Step 6: Connecting the Power
Plug the power cords and switch on both power supplies on. When the power is
switched on, the LEDs on the front of the VTrak will light up.
Figure 22.VTrak E310f/s front panel LED display
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
ten seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• Controller LEDs flash green if there is activity on that controller.
There are two LEDs on each Drive Carrier. They repo rt the presence of power
and a disk drive, and the current condition of the drive.
Figure 23.VTrak E310f/s disk carrier LEDs
After a few moments the Power/Activity should display Green. If there is no disk
drive in the carrier, the Power/Activity LED will remain dark.
Power
Controller-2 Activity
FRU Status
Logical Drive Status
Controller-1 Activity
Controller Heartbeat
Disk Status
Power/Activity