SPECIFICATION FOR DOMESTIC WATER HEATERS
And Steam as the Energy Source
Furnish and install the following QuickDraw® water heater(s) as manufactured by PVI Industries, L.L.C. of Fort Worth, Texas.
| Model | GPM Recovery | Inlet Steam |
Qty | Number | 40° to _____°F | Pressure (psi) |
___ | ____________ | ________ | _______ |
___ | ____________ | ________ | _______ |
___ | ____________ | ________ | _______ |
Pressure Vessel and Heating Surfaces
The water heater will be constructed and stamped in accordance with Section IV, Part HLW of the ASME code. The water heater will be National Board Registered for a working pressure of 150 psi and will be pressure tested at
The heat exchanger will be a _____
with nonferrous waterside tube sheet, baffles, and tie rods. Heat exchanger will be constructed to ASME code and rated for 150 psi and 300°F service.
Tank Lining
The tank will be a plated with electroless nickel (EN). Plating will occur after the pressure vessel is completely fabricated and all welding is completed. The EN plating will be a
(continued)
PV 6619 9/02 | 1 |