PYLE Audio PCTL49820 user manual HOW to Turn on the Power, HOW to USE the Manual Mode

HOW TO TURN ON THE POWER

Note: If there is a thin sheet of clear plastic on the con- sole, remove the plastic.

1 Plug in the power cord (see page 8).

2	Locate the circuit
	breaker on the front of
	the treadmill near the
	power cord. Make
		Reset
	sure that the breaker
	is in the reset
	position.
	Stand on the foot rails
3
	of the treadmill. Find
	the clip attached to the
	key, and slide the clip
	onto the waistband of
	your clothes. Next, in-
	sert the key into the
	console. After a mo-
	ment, the displays and	Clip
	various indicators on
	the console will light.
	Test the clip by care-

fully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.

HOW TO USE THE MANUAL MODE

1 Insert the key fully into the console.

See HOW TO TURN ON THE POWER above.

2 Select the manual mode.

When the key is in- serted, the manual mode will automatically

be selected and the Manual Control indica-

tor will light. If a pro-

gram has been selected, press the Mode button repeatedly to select the manual mode.

3	Press the Start button or the Speed				▲ button to
	start the walking belt.
	A moment after the button is pressed, the walking
	belt will begin to move at 1.0 mph. Hold the
	handrails and begin walking.
	As you exercise, change
	the speed of the walking
	belt as desired by press-
	ing the Speed buttons.
	Each time a button is
	pressed, the speed will
	change by 0.1 mph. If a button is held down, the
	speed will change in increments of 0.5 mph.
	To stop the walking belt, press the Stop button.
	The Time display will begin to fl		ash. To restart the
	walking belt, press the Start button o			r the Speed		▲
	button.
	Note: During the first few minutes that the treadmill
	is used, inspect the alignment of the walking belt.
	Align the walking belt if necessary (see page 21).
	Change the incline of the treadmill as desired.
4
	To change the incline of the treadmill, press either
	of the Incline buttons until the desired incline level
	is reached.
	Follow your progress with the LED track and
5
	the four displays.
	The LED Track	—The
	LED track represents a
	distance of 1/4 mile (400
	m). As you exercise, the
	indicators around the
	track will light, one at a
	time, until you have com-
	pleted 1/4 mile. A new
	lap will then begin.
	Time display	—When the
	manual mode or the
	iFIT.com mode is se-
	lected, this display will
	show the elapsed time.
				Indicator
	When a workout program
	is selected, the	display
	will show the time remaining in the program and the
	time remaining in the current segment of the pro-
	gram. The display will alternate between				one num-

ber and the other every few seconds, as shown by the indicators in the display.

10