Parts:
|
|
|
| 6 |
5 |
|
|
|
|
3 |
|
|
| 4 |
|
|
|
| |
| 2 |
|
|
|
|
| Hardware List: | ||
|
| ID | Qty | Description |
|
| 1 | 1 | Base |
|
| 2 | 1 | Arm Assembly |
|
| 3 | 1 | Tube Cover |
|
| 4 | 1 | TV Plate |
|
| 5 | 1 | 4x4mm Wrench |
|
| 6 | 1 | 5x5mm Wrench |
|
| A | 4 | M4×8mm bolt |
|
| B | 4 | M4×12mm bolt |
|
| C | 4 | M5×8mm bolt |
|
| D | 4 | M5×12mm bolt |
1 |
| E | 4 | M5 washer |
A | B | C | D | E |
Display Adjustments
Roll Control
Function
Operation - Grasp the sides of the display, and roll it into the desired position. Then adjusting Roll Tension .
Angle adjusting
1. Adjusted with the TV plate .
With circumvolve the wall Plate ,TV can adjust in the direction of left, right ,up and down.Vertical Adjusting Angle is from - 5° to 20°.
Level Adjusting Angle is 20°.
Choose the desired angle and turn clockwise the Tension Knob on the right of the arm.
2. Adjusted with the arms.
With circumvolve the arms, TV can turning to two sides of the base
support until touch the vertical tube. First joint adjusting angle is ±90°, second is ±90°,third is ±135° .
Vertical height adjustment
You can adjust the arm assembly up without any other action, but before you lower the arm assembly, you should push the plastic button first.
0~110mm vertical height adjustment. | ±90° | ±135° | |
| ±90° | ||
|
| ||
Caution: The turning | - 5°~20° |
|
|
angle is not too large. |
|
| |
Or it may result in |
|
|
|
personal injur y or | 20° Tension Knob |
| |
product damage. |
| ||
Use Wrench to adjust the degree of those joints.
Has correctional function: If the wall plate were installed imbalance, you can adjust the TV plate
to lever off the assembly. Adjust angle is 10°.
Fig 7
