PYLE Audio PDWM2200 user manual Specifications, Belt Pack Transmitter, Overall system, Receiver

SPECIFICATIONS

A. Overall system

1.Oscillation mode:

2.Carrier Frequency Range

3.Frequency Stability:

4.Max Deviation:

5.Dynamic Range:

6.S/N Ratio:

7.T. H. D:

8.Frequency Response

9.Operating Range:

B. Receiver

1.Sensitivity:

2.Image Rejection:

3.Stability:

4.Audio output:

5.Power supply:

C. Transmitter

1.Mike capsule:

2.Antenna:

3.RF Output:

4.Spurious:

5.Power Supply:

Quartz controlled VHF160~270MHz +/-0.005%

+/-56KHz with level limiting >110dB

>100dB

<0.5dB 60Hz-18KHz 30M

6dB V at SIN >70dB >60dB

>80dB

-12db/600ohm unbalanced 12V DC/500mA

Handheld: dynamic

Headset or lavalier MIC: condenser Built-in housing(Handheld MIC) external(Belt pack)

<10mW <-40dBC

9V battery

BELT PACK TRANSMITTER

BATTERY COVER 9V BATTERY MIC IN

POWER INDICATOR

POWER SWITCH

OPEN CLOSE

LAVALIER MIC HEADSET MIC

1.Open the battery cover to install a 9V battery as per correct polarities.

2.Move power switch to ON position. Power LED indicator will flash once and then go off. This indicates correct operation. If power LED indicator lights red, this indicates the battery is Iow. Please replace with new battery.

3.Plug the 3.5mm connector of headset mic to MIC in jack of transmitter.

4.Before operation, please confirm that the frequency of transmitter is same as the frequency of receiver.

5.When speak to the MIC, please keep 2-3cm distance between mouth and mic head.

6.If the system will not be used for a long time, please take out battery from transmitter to avoid damage by battery leakage.

6 3