PYLE Audio PDWM4300 operation manual Audio Output Jack Volume Switch Audio Switch Power Switch

Using the supplied audio cable, connect from the MIXED jack socket to the "MIC IN" / "LINE IN" socket on amplifier. Alternatively, you can connect an optional XLR cable from the "XLR MIXED" socket on the receiver to a professional mixer. Connect the mains power adaptor from "DC 15V" jack to a suitable mains power socket.

Installation Location:

At least 3 ft. above ground level

At Least 3 ft. away from wall

AUDIO OUTPUT JACK

VOLUME SWITCH

AUDIO SWITCH	POWER SWITCH
LOW BAT
ON MUTE -20dB	0dB OFF ON

MIC/LINE AUDIO POWER ATTENUATION POWER

LOW BATTERY LED

POWER LED

BELT CLIP

BATTERY COVER

9V +

ANTENNA

HEADSET MIC

LAVALIER MIC

MIXED CH-1 SQ4 SQ3 SQ2 SQ1

XLR MIXED

7

DC IN

15V/500mA

Open the battery cover to install a 9V battery (check polarities). Move the power switch to the ON position. The power indicator will be green to indicate normal operation. If the LOW BAT indicator turns red, replace with a fresh battery promptly.

Before operation, please confirm that the frequency of transmitter is same as the frequency of receiver. Plug the 3.5mm connector of headset mic to screw-lock socket of transmitter. Move the audio switch to ON position. The MUTE switch cuts off the audio output without shutting off the transmitter.

ATTENUATION is for volume adjustment. Move it to 0dB position to get normal volume output. Move it to -20dB position to reduce distortion and avoid feedback.

If the system will not be used for a long time, please switch off the transmitter to avoid power consumption.