FRONT PANEL
REAR PANEL
3
1 | 4 | 5 | 6 | 7 | 8 | 9 |
3
10 11
PDWM4300 VHF PROFESSIONAL FOUR CHANNELS WIRELESS MICROPHONE SYSTEM
VOLUME | VOLUME |
| VOLUME |
RF | AF LEVEL | RF | AF LEVEL |
CHANNEL 1 |
| CHANNEL 2 |
|
POWER
RF | AF LEVEL |
CHANNEL 3
VOLUME
RF | AF LEVEL |
CHANNEL 4
|
|
| DC IN |
|
|
| 15V/500mA |
XLR MIXED | MIXED | SQ1 | |
|
|
| |
17 | 18 | 19 | 21 |
|
| 20 |
|
16 | 2 | 12 |
|
|
| 13 | 14 | 15 | 16 | |
|
|
|
| |||||||
1. | Power Indicator | 7. | AF Indicator | 13. |
|
| ||||
2. | Power Switch | 8. | RF Signal Indicator | 14. |
|
| ||||
3. Antenna | 9. | AF Indicator | 15. |
|
| |||||
4. | RF Signal Indicator | 10. | 16. | Rack Mounts |
|
| ||||
5. | AF Indicator | 11. |
|
|
|
| ||||
6. | RF Signal Indicator | 12. |
|
|
|
| ||||
17.Balanced output jack 18.Unbalanced output jack
SQUELCH
Attach the two antennas and extend them vertically. Switch on the receiver. The red power indicator will come on. Switch on the transmitter. The red indicator RF/Channel1, RF/Channel2, RF/Channel3, RF/Channel4 will come on to indicate signal reception. The green AF LEVEL meters indicate the audio level.
Adjust the volume of receiver, transmitters and amplifier. Please switch off the receiver, transmitters and amplifier when the wireless microphone system is not being used.
The squelch control on the rear of the receiver is preset at the factory. If you must use the system in an area with considerable RF interference and there is some noise from the receiver when your transmitter is off, you can adjust the squelch control so that the system will receive the signal from your transmitter only but squelch or eliminate the unwanted background RF noise. This adjustment can
cause reduction in useable range of the wireless transmitter, so set the control to the lowest position that reliablely mutes the unwanted RF signals.
Note that switching the microphone on and off can cause interference that will be heard if the microphone volume level of the amplifier system is still set high.
6
