PYLE Audio PRJHD198 user manual Trouble Shooting

Trouble Shooting

TROUBLE SHOOTING

Please refer to this chapter when you encounter a problem list prior to contacting your dealer.

Problem:	Possible solution(s):
No power	1, The projector donot connect the power cable
	2, Donot open the projector .
	3, Fuse broken
Remote doesn't operate	1,Projector turned on to quickly after
	last turn off (needs 5 minutes).
	2,Batteries defect.
	3, Aim remote correctly at IR receiver.
No image	1, Please remove the len cap at first
	2, Projector turned off.
	3, Selected the wrong input signal.
	4, the mainboard are broken . Please
	Replace this mainboard.

		Caution
About the installation		About Open and close the projector
In order to improve the projector service life,
It shouldnot place in a wet and		when open the projector ,connect
ventilation condition
		the power cable and press the "power"
Donot put the projector under the sunshine		key on the panel .the projector will
directly		work ,but the lamp will be bright more
Projector working temperature: 0	+70	and more .After 5 minutes, the lamp wor
		normally
Projector store temperature : -20	+70
Donot block the ventilation-window		when close the projector , press the powe
		key again . And then the lamp shut off.
of projector		But the fans still work until 5minutes late
If the projector interior temperature		When close the projector ,donot pull out
are too hot , the machine will be shut		the power cable directly . After 5minutes
off automatically.This is hot -		the projector will shut off automatically.
protected system.
So please clean the filter of projector

per month . It is very important. Donot let the dust cover the filter.

Warning

Fans will adjust the temperature It is controlled by system when the projector work, the fans turn slowly or quickly so the fans noise are different But it is normal

when the projector work ,donot pull out the pwer cable If the fans stop to work,it will cause the projector interior temperature very high, so it may damage the projector.