Hardware List: Actual parts appearance and the quantity may different with illustrated.
UP
UP | 2 | 2 |
|
1
3
G | H | I | J | K |
After determining the height of stand, follow the installation instructions in below to install wall mount to different kinds of wall
Wooden wall:
Us i n g a a w l o r n a i l t o m a k e where the nails are located, as shown as fig.2b. Distance between two nails for fixing wall mount must not less than 12”.
level and located at center. Use wall mount as a template to mark the location of other three holes and drill the same holes. Fix the wall mount to the wall with 4 long bolts(H) and washers(J).
Concrete wall:
Using the wall mount as template to mark 6 holes location on the wall. Three holes are located at the top row of the slots and three more are located at the bottom row. The outer holes must be fall to the left and right of the two holes in the middle of the
mount. Please make sure these holes are level and at least 6” between any two lines.
anchors(I) into each of these holes. Attach the wall mount to the wall using 6 long bolts(H) and washers(J).
ID | Qty | Description |
1 | 1 | Wall mount |
2 | 2 | Bracket |
|
|
|
3 | 2 | Safe bolt |
A | 4 | M4×12mm bolt |
|
|
|
B | 4 | M4×16mm bolt |
|
|
|
C | 4 | M5×16mm bolt |
D | 4 | M6×16mm bolt |
ID | Qty | Description |
E | 4 | M5×36mm bolt |
F | 4 | M6×36mm bolt |
G | 4 | Square washer |
|
|
|
H | 6 | Long bolt |
I | 6 | Wall anchor |
J | 6 | Long bolt washer |
K | 4 | Spacer |
1 | |
| |
J | H |
Fig 2b | Fig 2c |
Using
|
|
|
|
|
| ||||
