PYLE Audio PSW501SF manual Box wrench, Wooden wall, Brick, Concrete and Stone wall

Hardware List: Actual parts appearance and the quantity may different with illustrated.

22

1

5

3

4

A-F G H I J K

After determining the height of stand, follow the installation instructions in below to install wall mount to different kinds of wall -wooden, brick, concrete and stone.

Wooden wall:

Using a awl or nail to make where the nails are located, as shown as Fig.3b. Distance between two nails for fixing wall mount must not less than 16”. Slide the plate into position as required.(Fig.3c) Pre-drill these holes with a 5mm drill bit to at least

40mm in deep hole. Use wall mount as a template to mark the location of other three holes and drill the same holes. Please make sure these holes are level and eudipleural. Fix the wall mount to the wall with 4 long bolts(H) and washers(J)by Box wrench(5).

Brick, Concrete and Stone wall:

Using a awl or nail to make where the nails are located. Distance between two nails

for fixing wall mount must not less than 16” . Slide the plate into position as required. (Fig.3c) Pre-drill these holes with a 10mm drill bit to at least 50mm in deep hole. Use wall mount as a template to mark the location of other three holes and drill the same holes. Please make sure these holes are level and eudipleural. Insert wall anchors(I)

into each of these holes. Attach the wall mount to the wall using 4 long bolts(H) and washers(J) by Box wrench(5).

ID	Qty	Description
1	1	Wall mount
2	2	Bracket
3	1	Cable Cover
4	2	Safe bolt
5	1	Box wrench
A	4	M4×12mm bolt
B	4	M4×16mm bolt
C	4	M5×16mm bolt

ID	Qty	Description
D	4	M6×16mm bolt
E	4	M5×36mm bolt
F	4	M6×36mm bolt
G	4	Square washer
H	4	Long bolt
I	4	Wall anchor
J	4	Long bolt washer
K	4	Spacer

Fig		3b
		Balance-adjusting
1
J	H	5
Fig	3d

Plate

Fig 3c

Using balance-adjusting system on the plate, make sure whether wall plate is installed balance. If not, then slide the wall plate let pointer level in the center position.

-2- -7-