Step 2: Install the Cable Cover
Route the cables as required. Snap the cable cover into place onto
the rods (Fig. 2a), and then slide the cover into position as required. (Fig. 2b)
Fig 2a | Fig 2a |
Step 3: Attach mount to wall |
|
First, determine the height of stand
The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level.
The following two conditions are for determining the perfect height of stand:
1) the distance between wall and couch(Fig 3a).
2) the distance of eyelevel from ground level plus the distance measured from eyelevel of a person sitting on couch with viewing angle of 15°(Fig 3a).
For example:
1) the distance of ‘a’ is
2) the distance of ‘a’ is
3) the distance of ‘a’ is
The perfect height of stand centre will be anywhere within b, where you feel comfortable for viewing.
15 degree | b | |
viewing angle | ||
|
eyelevel
a
Fig 3a
WARNING
We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product.
Note: The supplied wall mounting hardware is not for use on steel stud walls or cold cinder block walls. If you are uncertain about the nature of your wall, please consult a qualified contractor. If the hardware you required is not included please contact your local hardware store.
Caution : This Product LCD /Plasma Wall Mount Bracket is intended for use only
with the maximum weights indicated .See apparatus instructions .Use with products heavier than the maximum weights indicated may result in instability causing possible injury .
Step 1: Attach bracket to TV
Check your TV manual to confirm the diameter of bolt to be used or choose an
appropriate bolt according to size, height and position of the holes on your TV. See pages
For correct installing, make sure that hook of ever y bracket must facing down. Use selected bolts, spacers and washers for installing bracket a t t h e b a c k o f d i s p l a y. A d j u s t t w o b r a c ke t s t o e q u a l h e i g h t s a n d level. Once aligned, tightly secure the bolts.
IMPORTANT: Don't force the bolt into the hole, which will cause a damage of equipments and injure of person. Don't use electric drill to fasten any bolts.
|
|
|
|
|
|