SPECIFICATIONS
Maximum Torque | 400 ft./lbs. |
Blows Per Minute | 1000 |
Free Speed RPM @ 90 PSI | 7000 |
Maximum Working Pressure | 90 PSI |
Air Inlet | 1/4” NPT |
Recommended Hose Size | 3/8” I.D. |
Air Consumption @ 90 PSI | 4.2 SCFM |
ASSEMBLY
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.
OPERATION
Operation
Before each use:
●
●
●
Drain water from air compressor tank and condensation from air lines. See air compressor’s operators manual.
Disconnect the tool from the air supply before lubricating or changing sockets.
Lubricate tool, see “Maintenance” section in this manual.
Impact wrench sockets and accessories must be used with this tool. Do not use hand sockets and accessories.
Select the required impact socket. This tool has a 1/2" square drive, use 1/2” deep sockets. Use 1/2” extensions only when needed.
●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier. See the “Accessories” section of this manual.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
●
●
●
Turn air compressor on and allow air tank to fill.
Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure.
Set torque regulator, see chart, to set the desired setting to avoid over tightening.
IMPORTANT: These torque values can vary depending on the size of the air compressor and the cubic feet of air (SCFM) the air compressor delivers.
Line up desired torque # with raised pin
#1 approximately
5- ENG | D22725 |
