Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update is complete. Don’t remove the AC mains lead during the update. Removing the AC mains lead while the update is in progress may damage the unit.

Software of this unit can be updated automatically by the following methods at the specified time. (Default setting is 3 a.m. > 82, Software Update in Standby)

If a software (firmware) update is available, a notification is displayed.

New software version has been found. The software will be updated automatically after this unit is switched to standby.

Do not disconnect the AC mains lead.

Update of the software (firmware) will start when the unit is turned to standby mode.

-From broadcasts

-From Internet§

The unit’s display during the update

e.g.,

To update the software (Firmware) immediately, use the following function:

-Software Update Now ( Broadcast ): Software of this unit will be updated from broadcasts if update information is detected.

-Software Update Now ( Internet )§: Software of this unit will be updated from Internet if update information is detected.

§Network connection and setting are required. (> 17, 21)

When “FINISH” is displayed, update of the software (firmware) has completed.

It may take up to a few hours until the update is completed

depending on the network or broadcast environment.

The timer recording always takes preference over the software (Firmware) download; if the timer recording is scheduled to start, the downloading will be performed at the next opportunity.

You can also download the latest software (firmware) from the following website. http://panasonic.jp/support/global/cs/

84 VQT4L30

Page 84
Image 84
Panasonic DMR-PWT530, DMR-PWT635 operating instructions Software Firmware Update, Unit’s display during the update