Panasonic DMR-PWT635, DMR-PWT530 operating instructions Messages on the unit’s display

Messages on the unit’s display

The following messages or service numbers appear on the unit’s display when something unusual is detected.

SET 

(“∑” stands for a number.)

The remote control and main unit are using different codes. Change the code on the remote control. (> 87)

CONV

Selected titles in the USB HDD are being converted.

Do not disconnect the USB HDD from this unit.

GUIDE

TV Guide data is being downloaded.

HARD ERR

If there is no change after switching the unit to standby mode and turning it on, consult the dealer.

NoREAD

•The disc is dirty. (> 10) The unit cannot play.

•The lens cleaner has finished cleaning. Press [< OPEN/CLOSE] on the main unit to eject the disc.

Troubleshooting

PLEASE WAIT

•Displayed when the unit is started and is switched to standby mode.

•There was a power failure or the AC plug was disconnected while the unit was on. The unit is carrying out its recovery process. Wait until the message disappears.

PROG FULL

There are already 32 timer programmes. Delete unnecessary timer programmes. (> 34)

REMOVE

The USB device is drawing too much power. Remove the USB device.

START

Update of the software (firmware) is started. You cannot operate the unit until the update is complete. (> 84)

SW-DL

Software (firmware) is downloading.

Download will stop when the unit is turned on, or the timer recording starts. (> 84)

UNSUPPORT

The media is not supported.

UPD /

(“∑” stands for a number.)

The software (firmware) is being updated. You cannot operate the unit until the update is complete. (> 84)

VQT4L30 93