| SPECIFICATIONS |
Maximum Torque | 500 ft./lbs |
Blows Per Minute | 1,000 |
Maximum Working Pressure | 90 PSI |
Air Inlet | 1/4” NPT |
Recommended Hose Size | 3/8” I.D. |
Air Consumption @ 90 PSI | 4.2 SCFM |
|
|
| ASSEMBLY |
|
|
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.
OPERATION
Operation
Before each use:
●Drain water from air compressor tank and conden- sation from air lines. See air compressor’s operators manual.
Disconnect the tool from the air supply before lubricating or
changing sockets.
●Lubricate tool, see “Maintenance” section in this manual.
Impact wrench sockets and accessories must be used with
this tool. Do not use hand sockets and accessories.
●Select the required impact socket. This tool has a 1/2" square drive, use 1/2” deep sockets. Use 1/2” extensions only when needed.
1/2” Square Drive
Trigger
Air Inlet 
●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
●Turn air compressor on and allow air tank to fill.
●Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure.
●Set torque regulator, see chart, to set the desired setting to avoid over
| tightening. | Line desired torque # up with | |
IMPORTANT: These torque values can vary | |||
indent | |||
depending on the size of the air compressor |
| ||
and the cubic feet of air (SCFM) the air | #1 approximately | ||
compressor delivers. | |||
#2 approximately | |||
● | Place tool in forward or reverse position. #3 approximately | ||
| Place in “F” position for forward or “R” | #4 approximately | |
|
| ||
| position for reverse. |
| |
● | Depress the trigger to operate tool. |
| |
|
| ||
● | Release trigger to stop tool. |
| |
|
| ||
● | Always disconnect air supply when changing sockets. | ||
| |||
● | When job is complete, turn the air compressor off and store as described in the air | ||
| |||
| compressor operator manual. |
| |
5- ENG | D22724 |
