Contents
OPERATING GUIDE
PROFESSIONAL POWER AMPLIFIER
PTA3000
IMPORTANT SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
Duration Per Day In Hours
Sound Level dBA, Slow Response
UNPACKING
SERIES PROFESSIONAL POWER AMPLIFIER
INSTALLATION
BASIC SETUP
5 FAULT LEDS FAULT
FRONT PANEL FEATURES
2 POWER LED POWER
3 SIGNAL ACTIVITY LEDS SIGNAL
NOTE FOR UK ONLY
BACK PANEL FEATURES
7 IEC MAINS CONNECTOR
U.S. DOMESTIC AC MAINS CORD
9 SPEAKON OUTPUTS
10 MODE SWITCH
11 GROUND LIFT SWITCH
13 COMBO INPUT CONNECTOR
16 THRU/LOW OUT JACKS
14 LOW CUT SWITCH
15 CROSSOVER SWITCH 150 Hz X OVER
INDUSTRIAL AND COMMERCIAL INSTALLATIONS
levels occur Then, as temperatures in the amplifier heat sinks increase, the automatic thermal-sensingcircuitry will cause high-speedoperation to occur. Depending upon signal conditions and amp loading, high-speedfan operation may continue or the fan may cycle continuously between high and low. This situation is quite normal. If cooling is inadequate, however, the amplifier thermal-sensingsystem may cause temporary shut down of the unit, indicated by the LEDs on both channels going dark. Inadequate cooling may be due to preheated air, reduces air flow resulting from blockage of inlet/outlet ports, severe amplifier overload, or short circuit conditions. Depending upon the available cooling air, operation should be restored relatively quickly, and the power LED on both channels will again be illuminated. In any event, action should be taken to correct the cause of the thermal shutdown. If the amplifier is not severely overloaded or shorted and air flow is normal in and out of the amplifier, then steps should be taken to provide a cooler environment for all the amplifiers. As a general rule, the cooler electronic equipment is operated, the longer its useful service life
AMPLIFIER CONFIGURATIONS
Page
4 Ohms EIA, 1 kHz, 1% THD
SPECIFICATIONS
RATED OUTPUT POWER
Stereo mode EIA both channels driven