PYLE Audio PTCDS2UI manual Preparation For Use Unpacking And Set Up, Important Notes

AC Outlet

TRANSIT SCREW

IMPORTANT NOTES

Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas.

Do not attempt to clean this unit with chemical solvents as this might damage the finish. Use a clean dry cloth. Operate controls and switches as described in the manual. Before turning On the power, make certain the AC power cord is plugged in. Store your CDs, In a cool area to avoid damage from heat. When moving the set, be sure to first disconnect the power cord.

PREPARATION FOR USE

UNPACKING AND SET UP

●Carefully remove the unit from the display carton and

remove all packing material from the unit.

● Unwind the AC power cord and extend it to its full length. ● Unwind the FM Antenna wire and extend it to its full length. ● Place the unit on a stable, level surface, convenient to an AC

outlet, out of Direct sunlight, and away from sources of excess heat, dust, moisture, humidity or strong magnetic fields.

●Raise the lid to expose the phonograph. The phonograph has

been secured for shipment with a transit screw. Use a coin or screwdriver to turn the transit screw clockwise. This will allow the Turntable to “float”.

●Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it Forward and down.

●Discard the stylus cover.

●Remove the twist-tie that was used to secure the tone arm during shipment.

●Release the tone arm lock lever.

●Connect the plug to your AC outlet.

TONE ARM LOCK LEVER

STYLUS COVER

POWER SOURCE

This product is designed to operate on 120V 60Hz AC only. Attempting to operate this system from any other power source may cause damage to the system, and such damage is not covered by your warranty.

NOTE: You will note that this system is equipped with domestic standard AC power -pin plug. If this plug does not fit into your existing AC outlet, do

not try to defeat this safety feature by filing the wide blade to make it fit into your outlet. If this plug will not fit into your outlet, you probably have an outdated

non-polarized AC outlet. You should have your

outlet changed by a qualified licensed electrician.

AC Plug

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture.

2