![](/images/new-backgrounds/1272083/27208313x1.webp)
Presetting the Controls Before Use
Since sudden high output levels from your Pyle Pro mixer can damage not only audio devices connected to the mixer output but your hearing as well (especially if you are using headphones), please adjust the mixer’s controls BEFORE connecting AC power or turning on the unit.
Set up the mixer controls like this before you start:
CONTROL | SETTING |
Power On/Off | OFF |
Balance | MID |
Gain | MID |
Tone Controls, Treble, Mid & Bass | 0 |
MIC 1/2, CH 1/2/3/4, Master & Cue Levels | 0 |
Crossfader | CENTER |
Connecting the Mixer Inputs
This mixer permits connection of up to eight (8) audio input sources,and two microphones. Such a system might include, for example:
Two Microphones | Two Microphones | Two Microphones | Two Microphones |
Two Turntables | Eight CD players | Two Turntables | Two Turntables |
Six CD players |
| Three CD players | Four CD players |
|
| Three Cassette Decks | One Rhythm Synth |
|
|
| One Cassette Deck |
Please observe the following:
Do not connect any audio source with a HIGH LEVEL OUTPUT to the LOW LEVEL PHONO 1 or PHONO 2 mixer audio input jacks (an audio source output with a volume control is HIGH LEVEL).
Connecting Microphones
Microphone 1. Connect a balanced/unbalanced low impedance (600 Ohm) XLR type mic OR a low impedance mic with a 1/4” plug to the MIC 1 jack in the upper left corner of the mixer control panel.
Use 1/4” or
MIC 1
Microphone 2. Connect a high quality balanced/unbalanced low impedance (600 Ohm) microphone with a 1/4” plug to the MIC 2 jack on the lower left corner of the mixer’s back panel.
MIC 2
Use 1/4” jack
Pyle Pro Mixer PYD1911/1955 Owner’s Manual – 5