ENGLISH
www.pioneerelectronics.com
Using the SP-C21 as a Center Speaker
The loudspeaker may be positioned above or below the TV. For best results align the front of the loud- speaker with the front of the TV. Due to the
Follow the instruction for your receiver and set the center channel to NORMAL in Pro logic modes, or SMALL in Dolby and DTS modes. This will ensure that any bass signals encoded in the center channel are redirected to the front speakers or
It is recommended to use a sound level meter to setup the center channel level from the receiver. Adjust the receiver center volume until the center channel sound level is equal to that from the front left and right loudspeakers. In the absence of a meter, initially set the level of each channel to be identical. All models in the range have sufficiently close sensitivities such that this is a good starting point. Now play a wide selec- tion of movies and listen carefully to the clarity of dialog, particularly in the presence of other effects such as explosions. Adjust the level until the dialog is clearly but naturally presented.
For best results the loudspeakers should be positioned at or above ear level.
INSTALLATION PRECAUTIONS
•Do not install this speaker system near a stove or other heating appliance, or put it in a place exposed to the sun. Such locations may cause the cabinet to change color and the speaker system to break down.
•Remember that the
Pioneer will not be responsible for any accidents or damage that may result from improper installation.
The
If this happens, turn off the power switch of the television set, and turn it on after 15 to 30 minutes. If the problem persists, place the speaker system away from the television set.
CABINET MAINTENANCE
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the cabinet is very dirty, clean with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and then wipe again with a dry cloth. Do not use furniture wax or cleaners.
•Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces.
3