8 – NetWare Driver Installation
Installing the NetWare Driver
8-2 FC2354601-00 A
8.3
Installing the NetWare Driver
NOTE: The QL2300.HAM driver may not be compatible with NetWare versions
earlier than 4.2.
Perform the following steps to install the NetWare driver in a previously installed
NetWare4.2, 5.x, or 6.x system.
NOTE: The following procedure modifies your NetWare STARTUP.NCF file to load
the driver automatically when your system boots.
1. Start NetWare and load the NetWare Install program from the NetWare
server prompt (SERVERNAME:).
Type the following command when you are using NetWare4.2:
LOAD INSTALL
Type the following command when you are using NetWare5.x or 6.x:
LOAD NWCONFIG
2. Select Driver options from the main menu.
3. Select Configure disk and storage device drivers.
4. Select Select an additional driver.
5. Press INSERT to install an unlisted drive r.
6. Insert the disk that contains the QLogic driver in an appropriate drive.
7. Press F3 and specify the root path as the disk drive (A:\).
8. Press ENTER to select the QL2300.HAM driver.
9. If prompted, select Yes to copy the driver.
10. You are prompted for the server directory. Type the path of the server
directory, or press ENTER to accept the default.
11. If necessary, select Select/Modify Drive r Parameters to modify the default
settings.
You can select a different PCI slot or select to not scan all LUNs. Press F10
to save the parameter settings.
12. Select Save parameters and load driver to complete the NetWare setup.
13. When finished, exit the installation pr ogram.
NOTE: If ASPI support is required for the SCSI devices, you must load the
NWASPI.CDM module, which is provided by Novell. For example:
LOAD QL2300.HAM
LOAD NWASPI.CDM