Connections
AC Power Cord
Insert the molded receptacle of the AC power cord into the AC power inlet on the back of the RAVE 522aa. Plug the AC line connector into the AC outlet. The power supply will accept from 100 to 240 Volts AC, 47 to 440 Hertz, without any changes. If a different type of IEC power cord is required than the one supplied with your 522aa, contact QSC’s Technical Services Department.
CobraNet
Connect one end of a
CobraNet and QSControl connection. Accepts rug- gedized or normal shell- less RJ45 plugs.
QSControl
Connect one end of a
Analog Audio Inputs and Outputs
Eight balanced audio inputs and outputs are provided, CH 1 INPUT - CH 8 INPUT and CH 1 - CH 8 OUTPUT. Plug the input signal terminal block connectors into the input recep- tacles. Connection
Omni In
The six Omni In connectors are
Logic Out
The four Logic Out connectors are
Analog audio input- bal- anced connection.
Analog audio input- unbal- anced connection. Note jumper wire between - and ground.
Omni In connections. Vari- able input must be 10k ohm variable resistor. Contact closure input can be a switch or relay contacts. These inputs can operate software “devices”. Nega- tive
Logic Out connections. Negative
(+)terminal logic level is switched using software.
14