QSC Audio AD-S52T manual Mounting, Safety Cable Attachment all models, Yoke Mount all models

Mounting

IMPORTANT! ENSURE THAT THE LOUDSPEAKER IS MOUNTED PROPERLY AND A SAFETY CABLE IS INSTALLED TO RETAIN THE LOUDSPEAKER IN THE EVENT OF A MOUNT- ING FAILURE. CONSULT A LICENSED, PROFESSIONAL ENGI- NEER WHEN ANY DOUBT OR QUESTIONS ARISE REGARDING A PHYSICAL EQUIPMENT INSTALLATION.

Safety Cable Attachment (all models)

On the back of the loudspeaker, near the bottom, is a safety cable attachment point. Install a safety cable strong enough to support several times the weight of the loudspeaker assembly in the event it may fall. The cable must be secured to a secondary support point which is also strong enough to sup- port several times the loudspeaker’s weight.

Yoke Mount (all models)

The included yoke mount handles most surface mounting applications. It is constructed of light, strong alloy and pre-drilled for ease of use. Integral bushings at the cabinet contact points ensure ease of positioning. A large center-hole is provided on the mounting surface side for wiring pass-through.

Mount the yoke to a surface strong enough to support the weight of the loud- speaker assembly using suitable hardware (not included). If any doubt exists as to the suitability or strength of the mounting surface, consult a qualified professional engineer. After securing the yoke to the mounting surface, have an assistant hold the loudspeaker in place while installing either the retain- ing knobs or socket head screws with flat and lock washers (AD-S282H and AD-S282HT only). Once the loudspeaker has been positioned for desired acoustic coverage, tighten the hardware securely.

Floor Monitor (I-282H only)

The I-282H yoke mount comes with two swivel feet, four self-adhesive rub- ber feet, and retaining knobs. Attach the two of the rubber feet to each of the two swivel outrigger bars, one at each end. Press firmly in place to ensure adhesion. Then attach each of the two swivel outrigger bars to the yoke mount using the two small retaining knobs included. The rubber feet should be oriented away from the yoke mount. Swivel the outrigger bars per- pendicular to the long axis of the yoke and tighten the retaining knobs. Set the completed yoke assembly on the floor, resting on the rubber feet. Place the loudspeaker into the yoke and secure using the two large retaining knobs provided. Position the loudspeaker for desire acoustic coverage and tighten the retaining knobs securely.

Pole Mounting (I-282H only)

On the bottom of the I-282H is a pole cup that accepts 1.375” or 1.500” (35

mmor 38 mm) pole diameters. For pole mounting, lift the loudspeaker into position over the pole end and set it onto the pole. Ensure the pole is fully and firmly seated into the pole cup of the loudspeaker.

OmniMount (all models)

For applications requiring the use of OmniMount’s Pro 60.0 mount, there is an adapter plate included. The adapter plate is used between the OmniMount bracket and the loudspeaker cabinet. Orient the plate with it’s curved side toward the loudspeaker and its safety cable access cut-out toward the bot- tom of the loudspeaker. Attach to cabinet using the provided M4 x 18mm self-tapping screw. Consult OmniMount’s literature and installation recom- mendations for proper and safe application of their product.

We recommend the use of M8 x 1.25 x 50mm bolts for securing the OmniMount bracket to the loudspeaker cabinet.

Attach safety cable here

For enhanced security, use the included M10 socket head screws to secure the loudspeaker to the yoke mount.

OmniMount adapter plate-

Attach to cabinet using provided M4 x 18mm self tapping screw, then attach OmniMount following manufacturer’s recommendations.

5