QSC Audio AD-S52T manual Connection, AD-S282H

Connection

I-282H

PASSIVE: Set the BI-AMP / PASSIVE selector switch to PASSIVE. Con- nect the full-range + input signal to Speakon pin 1+ and the full range - input signal to Speakon pin 1-. The two Speakon connectors wired in paral- lel, allowing a second I-282H loudspeaker (also set for PASSIVE operation) to be connected directly to the remaining Speakon connector.

ACTIVE: Set the BI-AMP / PASSIVE selector switch to BI-AMP.Con- nect the low frequency + signal to Speakon pin 1+ and the low frequency - signal to Speakon pin 1-. Connect the high frequency + signal to Speakon pin 2+ and the high frequency - signal to Speakon pin 2-. A second I-282H loudspeaker (also set for BI-AMPoperation) may be connected in parallel by connecting it to the remaining Speakon connector using a four wire Speakon connection.

I-282H Speakon pinout

Speakon plug pinout as viewed from wire-side

AD-S282H

PASSIVE: Set the BI-AMP /PASSIVE selector switch to PASSIVE. Connect the input to the PASSIVE + and PASSIVE - terminals on the rear of the loudspeaker. Do not use second set of terminals marked HF + and

HF -.

BI-AMP:Set the BI-AMP / PASSIVE selector switch to BI-AMP.Con- nect the low frequency signal to the terminals marked LF + and LF -. Con- nect the high frequency signal to the terminals marked HF + and HF -.

AD-S282HT

Connect the input to one set of the + and - terminals on the rear of the loudspeaker.

Additional loudspeakers may be connect to the second set of + and - ter- minals.

AD-S282H terminal pinout

AD-S282HT terminal pinout

7