Specifications

OUTPUT POWER	FTC: 100 Watts at 70V, all channels driven (20 Hz.-20 kHz., 0.2% THD)
	EIA: 100 Watts at 70V, all channels driven (1 kHz, 0.1% THD)
	Bridged Mono: 200 Watts at 140V, all channels driven (20 Hz.-20 kHz., 0.2% THD)
DYNAMIC HEADROOM	1 dB
DISTORTION	SMPTE-IM Less than 0.02%
	Typical 20 Hz.-20 kHz., 10 dB below rated power Less than 0.10%
	Typical 1 kHz. and below, full rated power Less than 0.03%
FREQUENCY RESPONSE	+0.0, -3.0 dB: 8 Hz. to 70 kHz (LF filter OFF).
	±0.4 dB: 20 Hz.-20 kHz.
DAMPING FACTOR	>500 for 70V (5 kHz. and below)
SIGNAL to NOISE	-100 dB (unweighted, 20 Hz.-20 kHz.)
	35 dB (56 X, gain control set to 0 dB attenuation)
INPUT SENSITIVITY	1.26 Vrms (for rated power into 70V line)
INPUT CLIPPING, Vrms	6 Vrms (+18 dBu)
INPUT IMPEDANCE	6k ohms unbalanced , 12k ohms balanced
AMPLIFIER PROTECTION	Short circuit, open circuit, thermal, ultrasonic and RF protection. Stable into reactive or mismatched
	loads.
COOLING	Continuously variable speed fan; back-to-front air flow through heat sink tunnel
LED INDICATORS	Front Panel: POWER (green), 8 each (1 per channel) SIGNAL (green) and CLIP (red) 4 each (1
	per channel pair) BRDG (yellow), 4 each (1 per channel pair) PAR (orange)
CONNECTORS	Input: (8) 3-pin terminal block ("euro" or "Phoenix" type) Output: (2) 8-pin detachable high current
	terminal block connectors Control & Monitoring: (4) QSC DataPort connectors
LOAD PROTECTION	Turn-on/turnoff muting, AC coupling (DC fault blocking), Clip limiting.
FAULT ISOLATION.	Individual channel fusing.
OUTPUT CIRCUIT TYPE	AB + B
POWER REQUIREMENTS	Refer to voltage specified on rear panel serial number label. Configured at factory for 100, 120 or 230
	VAC, 50- 60 Hz.

CURRENT CONSUMPTION (all channels driven, 120 VAC) Idle 0.6 Amp. 1/8 power*, 70V 6.3 Amp. 1/3 power**, 70V 9.4 Amp.

*NOTE: 1/8 power is representative of typical program material with occasional clipping. **1/3 power is representative of program material with severe clipping.

CONTROLS & INDICATORS Front: AC POWER switch, (8) gain controls

Back: (4) 10-position DIP switch blocks (1 per channel pair):

Clip Limiters

Stereo/Parallel/Bridge mode selection

Low frequency filter on/off

Low frequency filter selection of 50 or 75 Hertz.

DIMENSIONS 19.0" (48.3 cm) wide, 3.5" (8.9 cm) tall (2 rack spaces) 14" (35.6 cm) deep (from front mounting rails) including rear support ears

WEIGHT 21 pounds ( 9.5 kg) net, 27 pounds ( 12.3 kg) shipping

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

QSC Audio CX108V user manual Specifications

Models: CX108V

SPECIFICATIONS