QSC Audio DSP-30 manual Use How to Recall a Preset from the Front Panel, To Recall A Preset

Use: How to Recall a Preset from the Front Panel

TO RECALL A PRESET-

1- Press the BROWSE key until the desired preset number shows in the display. The selection display flashes until Step 2 (below) is completed.

2- Press the ACCEPT key to activate the selected preset in the DSP. Once the preset is active, the display will stop flashing.

Note! The ACCEPT button must be pushed within 30 seconds of selecting the preset. If a longer time passes, the DSP-30 will revert to its original preset.

Additional Tips:

a)Recalling presets will typically be done without the use of a PC by using the Browse and Accept buttons on the front panel. However, a PC with Signal Manager software may be used if desired. Refer to the on-line Help file to learn more about this.

b)Each preset can be dramatically different from one another. For that reason, when a preset is changed the outputs will mute, the DSP will be reconfigured, and then the outputs will unmute. This happens in fractions of a second. This ensures that undesired transients are minimized during preset changes. For live shows, this limits the changing of presets to pauses in the program material (like in between songs or sets).

c)The front panel buttons can be ‘locked’ to prevent undesired operation. The next page describes how to do this.

FRONT PANEL DISPLAY- Indications during preset operation and recall

Example- Preset 1 is active as indicated by the steady illumination of the display.

Press BROWSE once and the display will increment to “2.” The display will flash, indicating the ACCEPT button must be pushed to confirm the selection.

Press ACCEPT once and the display will change from flashing to steady illumination. The ACCEPT button must be pushed within 30 seconds of preset selection.

16