QSC Audio DSP-30 manual AC power receptacle, PRESET SELECTIONS buttons

Use: Control, Indicator, and Connector Descriptions

PC INTERFACE RS-232- This DB-9 female jack is for attaching the serial cable between the unit and the computer. Use this connection for loading your DSP configurations from the computer to the DSP and for “real-time” configuration tuning with Signal Manager software.

PRESET SELECTIONS buttons-

BROWSE- increments the Preset Memory and the Preset Number Display.

ACCEPT- after using the BROWSE button to choose a Preset number, press ACCEPT within 30 seconds to acti- vate the selected Preset.

NOTE! Pressing the ACCEPT button and holding for at least 3 seconds locks (disables) the BROWSE key to prevent accidental operation. The ACCEPT key must be pressed again and held for at least 3 seconds to “unlock” the BROWSE button so that other presets may be accessed again.

AC power receptacle-

The DSP-30 uses a detachable IEC standard power cord for connecting to a grounded AC source. To connect power: identify the proper end of the cord, match the orientation of the receptacle on the rear panel and insert firmly into the receptacle. The power supply will accept from 100 to 240 Volts AC, 47 to 63 Hertz. Make sure the power cord used is suitable for the line voltage the unit is connected to. If a different type of IEC power cord is required, contact QSC’s Technical Services Department to obtain the correct one.

13