Horn Rotation
The coverage angles for each model, as shipped from the factory, are show in the specifications section. If desired the
Example: An
How to Rotate the Horn
Note! It is always best to have an assistant when working with large assemblies such as this enclosure. The grill assembly is under tension when installed! Be sure to temporarily secure the grill with tape or have an assistant hold the grill edge while removing its retaining screws.
1- Remove the four screws from one side of the grill while having an assistant hold the grill from springing free. Remove the four screws from the other side of the grill. Place the grill and retaining screws aside.
2- Remove the eight horn retaining screws. Carefully lift the horn from its mounting re- cess while being careful not to tear or pull away the foam gasket between the horn and enclosure.
3- Rotate the horn to the desired position and set back into its mounting recess, being sure the gasket is properly positioned.
4- Install the eight horn retaining screws. Do not fully tighten the screws until all have been installed and
5- Position and align the grill assembly for reinstallation. Install four retaining screws on one side; do not fully tighten. carefully bend the grill around the front of the enclosure and install the remaining four retaining screws. It is easier to have an assistant hold the grill in place while installing the final four screws.
Grill retaining screws are to be torqued to
9