Quadra-Fire 7068-112 B. Vertical - Interior - Typical Installation, Shown On A Santa Fe

Castile & Santa Fe CE Pellet Stove

R

B. Vertical - Interior - Typical Installation		C. Through The Wall & Vertical - External
	(SHOWN ON A SANTA FE)	(SHOWN ON A SANTA FE)
	PREFERRED METHOD #1	PREFERRED METHOD #2

Rain Cap

	Flashing	305mm
		Minimum
	Firestop
		76mm Min.
152mm
Min.		76mm-76mm)
		Top Vent Kit
		Clean-out Cover
		on other side

Non-combustible Hearth Pad

Rain Cap

	Flashing	610mm
		Minimum
		Support
		Bracket
51mm minimum		every 1.5m
152mm		Wall Thimble
Minimum
		Tee
		Clean-out Cover
	Non-combustible Hearth Pad

Figure 28.1 Figure 28.2

D.Vertical into Existing Chimney

(SHOWN ON A SANTA FE)

Rain Cap

Flashing	305mm Minimum
Firestop
	Connector Adapter
Ceiling Support	76mm Minimum
152mm	152mm)Flue
Minimum	Connector
	76mm-152mm
	Top Vent Kit
	Cleanout Cover

Non-combustible Hearth Pad

Figure 28.3

We strongly recommend a minimum of 1.5m vertical, however above the eave is preferred.

Both installations are approved for mobile home installations. Must use 76mm to 102mm “L” or “PL” Listed pellet venting or Listed double wall pipe and Quadra-Fire Outside Air Kit in mobile homes. Single wall pipe is approved for residential installations only.

Air Clearance to Pipe:

This appliance was tested with standard 76mm Listed pellet clearance pipe to combustibles.

Pellet pipe manufactures Listed reduce clearance pipe may be use for reduce clearance from 76mm air clearance to no less than 25mm air clearance to combustibles for approved Listed pellet pipe.

Follow stove pipe manufactures listed air clearances to combustibles and installation instructions for all reduced air clearances installations.

The stove must be connected to a flue pipe conforming to current standards UNI 7129-7131 9615.

August 19, 2011 7068-112 Page 27