Quadra-Fire FG21SP-LP owner manual Appliance Set Up

4Appliance Set Up

1)After placing the Fogata Grande in the desired location, locate the oval hole in the fire bowl and be sure it is posi- tioned towards the leg where the gas connection is to be made.

Figure 1

2)With the letters provided, using tape, identify leg “A” as the leg to which the gas valve assembly will be attached.

Moving counter clock wise, lable the remaining legs “B”, “C” and “D” as shown in Figure 1. This will assit you in installing the logs after the gas connections have been made.

Figure 2

3)As shown in Figure 2, lay leg “A” on its face (on a smooth non abrasive surface to prevent damaging the surface) to begin the assembly of the gas system.

As show, place the gas valve control box on the inside of leg “A”. Locate the open end of the box assembly 1/2 inch back from the edge of the leg as shown in Figure 1.

Next position the top flange with the two key hole anchor- ing holes approximately 3/4 inch down from the seam as shown. Secure the two masonry screws through the top of the holes provided into the leg. Do not completely tighten since the control box will need to be removed in order to complete the final installation.

Once the screws have been installed, remove the valve control box in order to assemble the other componenets.

Figure 3

4)Take the pilot assembly, Figure 3, and locate the label on the burner that indicates the location for the pilot assembly. Insert the pilot hood over the burner tube and slide it forward so the top front clip slides over the tube of the burner. The lower bracket on the right side will need to be bent up with pliers to lock the pilot hood in place.

Figure 4

5)Place the stainless steel grate (heavy round bar grate, supplied with fire pit) in position in the lower part of the bowl. This grate will rest on top of the lower tabs.

Next place the screen over the grate so that the oval open- ing in the screen lines up with the direction of the stainless bars on the grate as shown in Figure 4.

Feed the burner flex line, pilot tube and piezo ignitor wire down through the center of the screen and grate and through the oval hole in the side of the bowl

The burner will rest flat on the upper tabs on the inside of the bowl.

Quadra-Fire • Fogata Grande