8 Operating Instructions
WARNING |
|
| - It is recommended that during long periods of non- |
|
| usage that the main power switch is turned to the “OFF” | |
|
|
| position. |
|
|
| |
Fire Risk |
| • Flame/Ember Bed Intensity Control | |
|
| - Turn the control knob clockwise to increase the | |
• Do not operate heater before reading and |
|
| |
|
| intensity. | |
understanding operating instructions. |
|
| - Turn the control knob |
Failure to operate heater properly may |
|
| intensity. |
cause fi re. |
| • | Flame/Ember Bed Motion Control |
|
|
| - Turn the control knob clockwise to increase the |
|
|
| motion. |
|
|
| - Turn the control knob |
A. Manual Controls | • | motion. | |
Access Controls | Heater/Blower Assembly Switch | ||
| - The heater/blower assembly will operate only if the | ||
• Controls are located behind the lower grille panel. To |
| ||
| switch is turned on. | ||
access the controls, lift up on the lower grille panel and |
| - When the heater/blower assembly switch is in the | |
rotate it forward. |
| ||
| “OFF” position, the heater can operate with fl ame but | ||
Function of Manual Controls |
| no heat. | |
• Main Power Switch
- Main power switch is used to provide power to all controls. When the main power switch is on, the heater is turned on by the manual control on the heater, the remote control (optional) and/or the wall switch (optional).
- When the main power switch is off, the manual switches, remote control and wall switch will not work.
HEATER/BLOWER ASSEMBLY SWITCH
MAIN POWER SWITCH
MOTION |
|
| HEATER MAIN |
|
|
| LEARN | ||||
|
| MOTION | POWER |
|
|
|
| INTENSITY THERMOSTAT |
|
| |
LEARN
INTENSITY
THERMOSTAT
Figure 8.1 Dashboard Controls
15 |
