Atlas II
Jumper Settings
Termination Power (TP) |
|
Enable termination power | TP jumper on |
Disable termination power | TP jumper off |
SCSI ID (A3, A2, A1, A0) |
|
Set drive SCSI ID | See ID settings table below |
Delay Spin (DS)
Enable spin delay | SP jumper off |
Disable spin delay | SP jumper on |
cStagger Spin |
|
Enable spin stagger | SS jumper on |
Disable spin stagger | SS jumper off |
Write Protect
Enable Write Protection
Disable Write Protection
WP jumper on WP jumper off
Jumper Locations
The Atlas II disk drive has two locations where user configurable jumpers are found. The primary jumper block (Front option connector J3) for the Atlas II is found on the front edge of the disk drive printed circuit board. Using these jumper pins you can establish the various drive configuration options. The second option jumper block is used to set the Atlas II termination options. This jumper block is found on the printed circuit board at the rear of the drive and is near the SCSI cable connector.
2 of 8