| Atlas II |
| Jumper Settings |
|
|
Stagger Spin |
|
Enable spin stagger | SS jumper on |
Disable spin stagger | SS jumper off |
Write Protect |
|
Enable Write Protection | WP jumper on |
Disable Write Protection | WP jumper off |
Jumper Locations
The Atlas II wide disk drive has two locations where user configurable jumpers are found. The primary jumper block (Front option connector J3) for the Atlas II wide is found on the front edge of the disk drive printed circuit board. Using these jumper pins you can establish the various drive configuration options. The secondary option jumper block provides an alternate method for setting primary drive features. The alternate jumper block is located at the rear of the drive and is incorporated into the SCSI cable connector.
The termination power option setting is located on the front edge of the printed circuit board and is adjacent to the J3 connector.
6 of 8
