| I V . C O M F O R T A D J U S T M E N T S | ||
7. | Remove the hardware that attaches the trapeze bars |
| |
| to the seat interface weldments. See figure 11. |
| |
8. | Move the trapeze bars up or down to the desired |
| |
| height. |
| |
NOTE: Change the seat dump by raising or lowering |
| ||
only one trapeze bar (front or rear). |
| ||
9. | Reinstall the hardware. |
| |
10. | Reinstall the seat. |
| |
11. | Reconnect the controller to the power base. |
| |
Seat Position |
| ||
You can move the seat forward or rearward by chang- |
| ||
ing the extrusion mounting position. |
| ||
To change the position: |
| ||
1. | Turn off the power to the controller. |
| |
2. | Make sure the power chair is in drive mode. | SEAT MOUNTING HOLES | |
3. | Unplug the controller connector(s) from the power | ||
| |||
| base. |
| |
4. Remove the seat from the power base. | Figure 12. Seat Position Adjustment |
5.Remove both extrusions from the bottom of the seat.
6.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or back- wards. See figure 12.
7.Fasten the extrusions back onto the bottom of the seat.
8.Reinstall the seat.
9.Reconnect the controller to the power base.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base.
To adjust the recline angle:
1.Pull up on the seatback release lever.
2.Lean forward or backwards to the desired position.
3.Release the lever.
Rival | www.pridemobility.com | 23 |
