I V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the controller for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 14.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Unplug the controller connector(s) from the power base.
3.Remove any wire ties securing the controller harness to the armrest.
4.Flip up the armrest so it is perpendicular to the floor.
5.Loosen the setscrew on the controller bracket
6.Slide the controller out of the armrest.
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrews in both armrests.
10.Route the controller harness to the back of the power base and plug in the controller.
11.Secure the controller harness to the armrest with wire ties.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or
CONTROLLER BRACKET
SETSCREW
Figure 14. Controller Position
Rival | www.pridemobility.com | 25 |
