| I V . C O M F O R T A D J U S T M E N T S | ||
Seatback Angle Adjustment |
| ||
If your power chair is equipped with an adjustable seat- |
| ||
back, you can adjust it to four (4) different angles: 90°, | JAM NUT | ||
102°, 105°, or 107°. | |||
To adjust the seatback angle: | ARMREST ANGLE | ||
ADJUSTING | |||
1. | Remove the adjusting screws from each seat hinge. | SCREW | |
| See figure 13. |
| |
2. | Set the seatback at the desired angle. |
| |
3. | Reinstall the adjusting screws to each seat hinge | ARMREST | |
| and tighten. | HEIGHT | |
|
| ADJUSTING | |
Armrest Width Adjustment | SETSCREWS | ||
You can change each armrest’s width independently of |
| ||
the other. | SEATBACK ANGLE | ||
NOTE: Changing the armrest width may increase the | ADJUSTING SCREW | ||
| |||
overall width of your power chair. |
| ||
To change the armrest width: | ARMREST KNOB | ||
| |||
1. | Locate the two armrest knobs on each side of the |
| |
| armrest receiver bracket. See figure 13. | Figure 13. Seatback/Armrest Adjustment | |
2. | Loosen the knobs. | ||
| |||
3. | Slide the armrests in or out to the desired width. |
| |
4. | Tighten the knobs. |
| |
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicu- lar to the floor. See figure 13.
2.Loosen the jam nut.
3.Turn the adjusting screw to raise or lower the front of the armrest.
4.Tighten the jam nut to lock the adjusting screw into place.
Armrest Height Adjustment
To change the armrest height:
1.Loosen the two setscrews located on the armrest receiver. See figure 13.
2.Raise or lower the armrest to the desired height.
3.Tighten the setscrews to secure the armrest.
24 | www.pridemobility.com | Rival |
