Quantum Scalar 50 Tape Drive Installation Instructions
Document
September 2007
3Insert the tape drive into the drive bay slowly until the connectors are seated (see figure 3).
4Tighten the tape drive captive screws using a flat blade screwdriver.
5Repeat steps 1 through 4 to install another tape drive in a different location, if desired.
Figure 3 Installing a Tape
Drive
Tape drive 1
Captive screw
Tape drive 2
Captive screw
Proceed to Cabling the Tape Drives.
Cabling the Tape Drives
After the tape drive(s) have been installed, you must connect SCSI or Fibre
Channel cables to each drive.
Refer to the following figures to cable the tape drives:
•Figure 4 SCSI full height drives
•Figure 5 Native Fibre Channel full height drives
•Figure 6 SCSI
•Figure 7 Native Fibre Channel half- height drives
•Figure 8 Stacked Library Configuration
Cabling the Tape Drives | 7 |
