Quantum Scalar 50 Tape Drive Installation Instructions
Document
September 2007
Setting the Tape Drive SCSI ID
Setting the SCSI ID Using the OCP
Figure 9 Setup Screen
Figure 10 Library Options Screen
The next step in the installation procedure is to set the required SCSI ID for the new tape drive.
Note: The library assigns SCSI IDs based on the drive order. Drive bay 1 = SCSI ID 1, drive bay 2 = SCSI ID 2, and so forth. It is only necessary to perform the steps in this section if you need to set the tape drive SCSI ID to an ID other than the default.
There are two ways to set the tape drive SCSI ID:
•Setting the SCSI ID Using the OCP
•Setting the SCSI ID from the Remote Management Pages
To set the tape drive SCSI ID on an Scalar 50 Series library with an LCD:
1From the operator control panel (OCP), press Setup from the Home screen. The OCP displays the Setup screen (see figure 9):
Enter
2Use the up and down arrows to highlight Cabinet and press Enter. The Cabinet screen displays (see figure 10):
3Use the up and down arrows to highlight Host bus and press Enter. The Host bus screen displays (see figure 11):
Setting the Tape Drive SCSI ID | 11 |
