Radio Shack 15-1186 size to fit text margins, illus of hole on wall , brackets in place, w

12A98 Printed in Taiwan
5. Use a Phillips screwdriver to loosen the two screws
on the back of the wall plate. Connect the antenna
cable/wires from inside the wall to the rear connec-
tors on the plate, then reti
g
hten the screws.
Warning: Be sure the exposed portions of the
cables/wires do not touch each other.
6. Use the two supplied short screws to secure the
plate to the center holes of the brackets.
7. Use a flat-bladed screwdriver to loosen the screws
at the back of the supplied three-pron
g
cable plu
g
.
Connect the 300-ohm antenna wire from the audio
and video outputs of the TV
(
or the left and ri
g
ht
channels of the FM radio
)
to the plu
g
, then reti
g
hten
the screws.
8. Insert the plu
g
into the wall plate’s
j
ack.
size to fit text
margins
illus of hole on wall
w
brackets in place
15-1186.fm Page 2 Thursday, July 15, 1999 1:47 PM