Radio Shack 15-133 manual Programming a Device, Programming Notes

Programming a Device

Your remote comes pre-programmed to operate SONY TVs, DVD players, VCRs, Audio Receivers and DIRECTV HD or HD with PVR satellite receiver. To control other brands, follow these steps to program your remote.

Before proceeding, find the codes for your devices in “Manufacturers Codes.”

1.Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD).

2.On the remote, press a device key (TV, CBL/SAT, DVD, VCR or AUD).

3.Press and hold P until the LED blinks twice, then release.

4.Enter the first five-digit code for your device. The LED blinks once as you enter each digit. If the code is correct, the LED blinks twice.

If the LED does not blink twice, repeat steps 2-4 and try entering the code again.

5.Aim the remote at the device and press Power (or PLAY, if the device does not have a Power key). The device should turn off. If it does not, repeat steps 2-5, trying each code for your brand until you find one that works. If you cannot find

a code that works, perform the steps in “Searching for Your Code.”

6.Repeat steps 1 to 5 for each device you want to program.

Programming Notes

If no key is pressed within 10 seconds, the remote control exits the programming.

To program a TV/DVD, TV/VCR/DVD, or TV/ VCR Combo, use the TV, DVD, or VCR device key.

If you have a VCR/DVD combo, you may need to set up both a VCR and DVD code.