9

Checking the Codes

If you have set up the remote using the
procedure in “Searching for a Code,” you
may want to know which ve-digit code is
operating your equipment.
1. On the remote control, press a device key
once (TV, CBL/SAT, DVD, VCR or AUD);
it blinks once. Then press and hold P until
the device key blinks twice.
2. Enter 9 9 0. The device key blinks twice.
3. To nd the rst digit of the code, press 1
once. Count the number of times the LED
blinks and write down the number.
If the LED blinks once, the rst digit is 1,
if it blinks twice, the rst digit is 2, etc. If
a code digit is 0, the selected device key
does not blink.
4. Repeat step 3 four more times for the
remaining digits, pressing 2 to nd the
second digit, 3 to nd the third digit, 4 to
nd the fourth digit, and 5 to nd the fth
digit. Write down the rest of the code and
keep it in a safe place.
Volume Lock
Your remote comes preset with the volume
locked to the TV mode. This conguration
allows you to control the volume of the TV
while in the CBL/SAT, DVD or VCR modes.
However, you may change the Volume Lock
setting to Global Volume Lock to a different
mode so that volume control is always
controlled through your audio receiver. After
that, you can perform Individual Volume
Unlock on a selected device to set its volume
control for independent operation.

Locking Volume Control to One Device

1. Press and hold P until the LED blinks
twice, then release.
2. Enter 9 9 3. The LED blinks twice.
3. Press the device key for the device you
wish to control volume (for example, TV).
The LED blinks twice.