Radio Shack 15-1990 owner manual Determining the 4-Digit Code

15-1990.fm Page 28 Tuesday, December 14, 1999 12:45 PM

Note: If your VCR’s original remote does not have a power key, manually turn on the device, insert a tape, and repeat Steps 1–6, using PLAY instead of POWER. When the device responds, press P. The red light blinks twice.

Determining the 4-Digit Code

After you set up your remote control using the man- ual code search, you can find which 4-digit code the remote control is set to by following these steps.

1.Press the device key (TV, VCR, or CBL) you want to get the manufacturer's code from, then hold down P until the red light blinks twice.

2.Press MUTE, MUTE, then VOL +. The red light blinks twice again.

3.Press VOL +, then count the number of times the red light blinks. This is the first digit of the 4-digit code.

Note: If the red light does not blink, the digit is a 0.

4.Press VOL – , then count the number of times the red light blinks. This is the second digit of the 4- digit code.

5.Press CH +, then count the number of times the red light blinks. This is the third digit of the 4- digit code.

6.Press CH – , then count the number of times the red light blinks. This is the fourth digit of the 4- digit code.

28