Radio Shack 15-1990 owner manual To Operate Your TV/VCR Combination

15-1990.fm Page 8 Tuesday, December 14, 1999 12:45 PM

TO OPERATE YOUR TV/VCR COMBINATION

1.Locate the codes for your TV/VCR combination in “TV/VCR Combinations” on Page 25 and write down the codes for your brand of device on the 3-in-One’s label.

2.Press VCR. The red light blinks.

3.Hold down P until the red light blinks twice, then enter the 4-digit code you wrote down in Step 1 using these keys:

	To Enter
Press	This Number
VOL +	1
VOL –	2
CH +	3
CH –	4
MUTE	5

When the red light blinks twice, the remote con- trol has accepted the code.

Note: If the code you entered is invalid, the red light blinks.

4.Point the remote control at your TV/VCR combi- nation and press POWER. Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes listed in “TV/VCR Combina- tions” on Page 25 for your TV/VCR combination.

Note: Some TV/VCR combinations require a second code to control volume. If you cannot get the volume to work, use the TV code listed in “TV VCR Combinations.” If no TV code is listed, follow the instructions in “Punch-Through” on Page 9 to control volume.

8