Choosing a Location
."%#76+10".
•You must use a Class 2 power source that supplies 12 volts DC and delivers at least 250mA. Its center tip must be set to positive and its plug must fit the transmitter's DC IN 12V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the transmitter or the adapter.
•Always connect the AC adapter to the transmitter before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the transmitter.
•Use only fresh batteries of the required size and recommended type.
•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
•If you do not plan to use the headphones for a week or longer, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.
%*115+0)"#".1%#6+10
Many factors affect the range of your system. To achieve the best performance:
•Position the transmitter as far as possible from other electronic devices such as TVs, receivers, or VCRs. Radio interference from these devices could affect your system’s performance.
•Position the transmitter away from large metal objects, as these could block your transmitter’s signals.
•Try several locations for the transmitter. Select the location that provides the best performance.
Your system’s overall performance depends on your home’s construction method, the other devices near the system, and other radio frequency sources in your home (such as cordless telephones).
75+0)"#%"219'4
Use the supplied 12V, 250mA AC adapter to connect the transmitter to AC power.
Plug the supplied AC adapter’s barrel plug into the transmitter’s DC IN 12V jack, then plug the adapter into a standard AC outlet. .
+056#..+0)"$#66'4+'5"
Your headphones require three AAA alkaline batteries or rechargeable batteries (neither supplied) for power. .
1. Remove the battery
compartment cover | ALK/RCH |
| |
on the left earpiece |
|
by pulling the side of |
|
the cover and lifting |
|
the cover off. |
|
2.If you are using
alkaline batteries, set ALK/RCH inside the compartment to ALK.
If you are using rechargeable batteries, set ALK/RCH to
RCH.
3.Place the batteries in the compartment according to the polarity symbols (+ and
4.Slide the cover back on until it clicks into place.
2
