Radio Shack 40-4093 owner manual +056#..#6+10, 100%6+06*52#-49+45, 242#4+06*.1%#6+10

4/9C["+P/9CNN"5RGCMGT

40-4093 OWNER’S MANUAL — Please read before using this equipment.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

Rý— Warning	# — Important
.	°

Your RadioShack 2-Way In-Wall Speaker	system makes it easy to mount your speaker
features a crossover, a 51/4-inch woofer for	flush with the ceiling or wall, making it ideal
rich lows, and a 1-inch tweeter for crisp	for unobtrusive use in a surround-sound
highs. The speaker can handle up to 80 watts	system. The frame and grille can also be
of music power. The wing-type mounting	painted to match the room’s decor.

— Caution	— Hint
± — Note

±"016'"±"

Do not paint the speaker element. We recommend you spray-paint the grille so paint does not block the holes.

."%#76+10".

Be sure not to cut into any existing wiring or plumbing hidden behind the wall.

+056#..#6+10

24'2#4+0)"6*'".1%#6+10

To mount your speaker, you need the following items (not supplied, available at your local RadioShack or online at RadioShack.com).

•drywall or keyhole saw

•wire stripper

•Phillips screwdriver

•pencil or marker

•18–20 gauge speaker wire

1.Be sure the mounting surface is between 3/8 inch and 11/4-inch thick, with at least a 2 3/4-inch clearance behind the mounting surface and no wall studs or other objects to block the back of the speaker.

2.Remove the inner cardboard disc from the supplied template/paint mask and keep it for later. Use the outer portion as a template to mark the cutout hole size and location for mounting the speaker.

3.Use a drywall or keyhole saw to cut the hole..

24'2#4+0)"6*'"52'#-'4

If you choose to paint the frame and grille, paint them and let them dry before you connect the speaker wire or mount the speaker.

To remove the grille for painting, insert a paper clip into one of the grille openings, then pull up. Or, you can carefully twist the plastic frame back and forth until the grille edge becomes exposed, then lift the grille to remove it.

Carefully remove the dust cloth from behind the grill and replace it after you are finished painting.±

You can also paint the frame to match your wall or ceiling. To prevent paint from entering the speaker, remove the grille and insert the supplied cardboard paint mask. After the paint is dry, remove the paint mask and replace the grille.

Paint Mask

%100'%6+0)"6*'"52'#-'4"9+4'5

±"016'5"±"

•Avoid routing the speaker wire near electrical wires.

•Do not nail or staple the speaker wire.

Your local RadioShack store sells a wide selection of speaker wire. We recommend you use wire that is color-coded or marked on one side to help you connect the wire correctly.

1.Route the speaker wire to the speaker from the receiver.±

2.Separate about 4 inches of speaker wire at each end.

1/4 inch

4 inches

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks

used by RadioShack Corporation.