Radio Shack 43-1090A, 43-1088A owner manual Entering a Pause, Dialing a Memory Number

1088A90A.fm Page 15 Tuesday, August 17, 1999 8:46 AM

Notes:

•Each TONE/ or REDIAL/P entry uses one digit of memory.

•If you try to enter more than 16 digits, the phone beeps 5 times and exits the programming mode. Start over at Step 2 and enter no more than 16 digits in Step 3.

4.Press MEM again, then enter the memory location number (0–9) where you want to store the num- ber. A tone sounds to indicate that the number is stored.

5.For each stored number, write the person’s or company’s name next to the appropriate location number on the supplied MEMORY direc- tory sticker. (Use a pencil in case you need to change the number later.)

6.Attach the sticker to the phone.

To replace a stored number, simply store a new number in its place.

Or, lift the handset, press TALK if the TALK/BATT LOW indicator lights, and press MEM twice. Then press the memory location number (0–9) you want to clear. A tone sounds.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you must also store a pause after the access code to allow the outside line time to connect. To do so, press REDIAL/P. Each press enters a 2-second pause. For a longer pause, press REDIAL/P additional times.

Dialing a Memory Number

To dial a number stored in memory, lift the handset or press TALK. The TALK/ BATT LOW indicator lights.

When you hear a dial tone, simply press MEM and enter the memory loca- tion number for the number you want to dial.

Note: If you select an empty memory location, the phone beeps 5 times. Try again.

15