Installation
!CAUTION !
The microphone boom swivels on the headset. Do not bend the microphone boom while you adjust it.
Ô NOTE Ô
When you are not using the headset, place it on the headset hanger. Otherwise (if you set it on a flat surface, for example), you might have to repeat these adjustments.
and you might hear an error tone. Return the handset to the base for about 3 seconds to reset the security
•If the battery pack becomes weak during a call, the handset beeps every 3 seconds and TALK/BATT flashes. When this happens, recharge the battery pack.
•If TALK/BATT does not light and the phone does not work, recharge the battery pack. (The battery power might be too low to light TALK/BATT.)
•About once a month, fully discharge the battery by keeping the handset off the base until TALK/BATT flashes. Otherwise, the battery pack loses its ability to fully recharge.
•The handset loses its security
•If you are not going to use your phone for an extended period, disconnect the battery pack. This increases the battery pack’s usable life.
The supplied battery pack should last for about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new
1.Insert the headset’s plug into the jack on the side of the base.
2.Place the headset on your head with the earpiece over either ear.
3.Adjust the headset band until it rests with almost no pressure on your ear and the top of your head.
If the headset is loose, press in slightly to tighten it. If it is tight, gently pull the headset band out to loosen it.
4.Hold the headset in place and adjust the microphone boom until it is about even with (but not in front of) your mouth. Experiment until you find the most comfortable position.! Ô
6