Your telephone connects directly to a modular telephone line jack. If your telephone wiring does not have a modular jack, you can update the wiring yourself using jacks and adapters (available at your local RadioShack store), or have the telephone company update the wiring for you. You must use compatible modular jacks that are compliant with Part 68 of FCC Rules. Ô
On a Desk Top
1.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.
2.Plug the modular cord’s other end into a modular phone line jack.
3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.
4.Route the adapter’s cord through the strain relief slot on the base, then plug the adapter into a standard AC outlet.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bracket. Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.
1.Make the AC adapter and the short telephone line cord through the hole on the bracket.
2.Slide the bracket into the notches on the base.
3.Plug the adapter into a standard AC outlet. Hook the cord on the notch of the bracket.
Ô NOTE Ô
The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall plate jack).
CAUTION
You must use
!a Class 2 power source
that supplies 9V DC and delivers at least 350mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
Installation
9
