Radio Shack 14-1107A Recording, Using the Built-In Microphone, Using an External Microphone

14-1107.fm Page 9 Thursday, July 1, 1999 11:15 AM

3.Adjust VOLUME to the desired listening level.

4.Press STOP/EJECT to com- pletely stop playback before it automatically stops. Press STOP/EJECT again to open the cassette compartment and remove the cassette.

RECORDING

Notes:

•Before you load a cassette tape for recording, be sure the cas- sette’s erase-protection tabs are in place (see “Preventing Acci- dental Erasure”).

•The CTR-94’s Automatic Level Control (ALC) circuit automati- cally adjusts the recording level. VOLUME has no effect on recording.

Using the Built-In

Microphone

The built-in condenser microphone is

ahigh-sensitivity microphone that easily picks up sounds, near or far. This is handy for recording confer- ences or lectures.

1.Load a blank cassette tape, or one you want to record over, into the cassette compartment.

2.Place the recorder 2 or 3 feet from the recording source.

3.Press RECORD to begin record- ing. Both PLAY and RECORD lock down.

CT R- 9 4 A C/B AT TE RY C AS SET TE RE COR DER

					MIC
RECORD	PLAY	REWIND FAST-F	STOP	PAUSE
			EJECT

4. Speak into MIC.

MIC

CT R- 9 4 A C/B AT TE RY C AS SET TE RE COR DER

RECORD	PLAY	REWIND FAST-F	STOP	PAUSE
			EJECT

Note: To temporarily stop record- ing, press PAUSE. To resume recording, press PAUSE again.

5.Press STOP/EJECT to stop recording.

Using an External

Microphone

You can connect an external micro- phone with a 1/8-inch plug to the re- corder. This is handy for when you want to record only an individual’s voice and exclude all other sounds in the surrounding area. Your local Radio Shack store carries a wide variety of external microphones.

Note: Connecting an external micro- phone automatically disconnects the built-in condenser microphone.

9